HydraBus + HydraNFC

HYDRANFC

New product

HydraNFC

149,00 €

The HydraNFC is a NFC shield hardware to sniff, read/write or emulate any 13.56MHz NFC tags (with the help of direct modes) for anyone interested in debugging/hacking/developing for NFC.

Introduction

The HydraNFC is an incredibly powerful and flexible 13.56MHz NFC sniffing/reading/writing/emulating plaform for 13.56MHz tags.

The HydraNFC is less expensive, more powerful/extensible than Proxmark3 Hardware and does not requires an FPGA (all is done by the MCU Cortex [email protected] with the help of HydraBus with ultra fast unique algorithm to sniff & decode in real-time PICC/PCD NFC cards).

Functionality in a glance

Below is a non-exhaustive list of what the HydraNFC brings to the table.

Ultra-Portable

Only 33 grams and 54x35x13 mm

Full Throttle NFC interaction

Direct Mode 0 access for unrestricted development

Ultra-Capable Out of the Box

Full support for all common NFC cards, real-time sniffing

Technical Specs

In addition to all HydraNFC specifications:
  • Supports Near Field Communication (NFC) Standards NFCIP-1 (ISO/IEC 18092) and NFCIP-2 (ISO/IEC 21481)
  • Completely Integrated Protocol Handling for ISO15693, ISO18000-3, ISO14443A/B, and FeliCa
  • Integrated Encoders, Decoders, and Data Framing for NFC Initiator, Active and Passive Target Operation for All Three Bit Rates (106 kbps, 212 kbps, 424 kbps) and Card Emulation
  • RF Field Detector With Programmable Wake-Up Levels for NFC Passive Transponder Emulation Operation
  • Programmable System Clock Frequency Output (RF, RF/2, RF/4) from 13.56-MHz Crystal
  • Programmable Modulation Depth
  • Dual Receiver Architecture With RSSI for Elimination of “Read Holes” and Adjacent Reader System or Ambient In-Band Noise Detection
  • Programmable Output Power: +20 dBm (100 mW), +23 dBm (200 mW)
  • Support any protocols under 13.56 MHz with modulation depth OOK (100%) or ASK (from 7% to 30%)
  • Support low level Direct Mode 0 (Raw RF Sub-Carrier Data Stream) or intermediate level (for special tags not ISO compliant like Mifare Classic …) Special Direct Mode for TX and Direct Mode 1 for RX using ISO encoders / decoders without protocol framing

Detailed functionality

  • Support of microSD (FAT16/FAT32) card up upto 32GB
  • Virtual Serial Port access through microUSB with VT100 terminal/shell
  • Basic UID read for Vicinity/ISO15693
  • Basic UID read for ISO14443-A/Mifare card 4 or 7bytes UID
  • Read MIFARE Ultralight tag content (full dump)
  • Tag Emulation UID ISO14443A & Mifare 1K
  • Sniffer mode in autonomous / stand-alone mode
  • Real-time ISO14443A sniffer mode

What's included

Hardware
  • 1x HydraBus (60mm x 37mm)
  • 1x HydraNFC Shield
  • 1x Case
  • 1x Pre-tuned Antenna

Shipping & Packaging

  • Each HydraNFC is dispatched from Europe - no need to worry about slow shipping times, import duties or damaged goods.
  • Packed in a sturdy compact box.
  • We provide world-wide shipping with express options.

If you are an educational-facility, reseller or need several units, please contact us.

No customer reviews for the moment.

Write a review

HydraBus + HydraNFC

HydraBus + HydraNFC

The HydraNFC is a NFC shield hardware to sniff, read/write or emulate any 13.56MHz NFC tags (with the help of direct modes) for anyone interested in debugging/hacking/developing for NFC.

Related Products

The HydraBus is an immensely capable, open source multi-tool for anyone interested in learning/developping/debugging/hacking/Penetration Testing for basic or advanced embedded hardware.

69,00 €